Question to Sterilizers.com chief trouble shooter:
What might remove burnt char from bottom of a Tuttnauer. Green fluid leaked after cleaning and burnt onto bottom of chamber. Chamber Brite not doing trick.
If there are melted plastic, chamber-brite will not do much. Make sure the dry cycle is not used. This may take a few cleanings.
It can be hard to clean unless you use an acid.
They will have to run another cycle or two using chamber-brite.
1. They can run a ½ package for no more than 30 minutes @250-260 degrees.
2. Vent chamber and empty reservoir, refill with fresh water.
3. While chamber is still slightly warm, use fine scotch-brite or a course side of a dish washing sponge and rub left to
right in the chamber (with the grain)
4. Wipe out chamber
5. Run another clean cycle
6. Do #2 again
7. Do #3 again
8. Do # 4 again